Roscoe

Hi All! I was wondering if anyone out there has used or is using a splash guard on their wand. I have seen these on the Web. It seems that it would be a handy tool when it comes to spraying walkways, walls near the ground, etc. to prevent splash back. I usually end up with more dirt on me than was on what I was cleaning. Any info would be appreciated. I enjoy all the great forums. Thanks! :newbie:

Thanks for all the replies guys. I'll keep on practicing. If I do get a little dirty. So what. Part of the fun of it huh? Just was thinking that the guard might help. I really enjoy all the info gained. This rookie has already learned a lot.Thanks! Oh yea! I also just bought an X-Jet. Looking forward to trying it out. See Ya!

the web site found one on was http://www.jackssmallengines.com/barens_nozzle_misc.cfm

Well That Is The Problem. I Found This A Few Months Ago By Mistake And Now Can't Find It. I Did A Search And Only Found Two. One From Karcher And The Other From Another Small Engine Company. I'll Have To Get That For You. It Was A Little Expensive. Around $56

Hi All! I have been enjoying reading all the great info on the forums since becoming a member. Well it's time for me to post a question to you pros. I am a newcomer to the powerwashing world and am trying to get a part-time business going. I have had good results doing residential work along with some business accounts. I have ran across a new one that I hope one or more of you could help me with. One of my customers is a local bank. While servicing the ATM the bank employee accidently set off the security ink cartridge that was installed inside the ATM. Purple ink went flying all over. Especially on the concrete surrounding the ATM. The bank approached me about getting this clean. I only have a cold water rig right now and have limited knowledge on what chemicals are best for the job. Do any of you have any suggestions? Thanks in advance for the help. Looking forward to working with you guys. Thanks! Lee Stone "Grime Fighters"

Thanks for the info guys. I'll try and put it to some use. I had thought about contacting the ink manufacturer. I am in law enforcement(my full-time job) and they may release that info I'm not sure but it is worth a try. Thanks again!