jdf

I have had a walkman for awhile just got a mp3 and love it

i have a 8x18 trailer and have out grown it but i do diff. type's of work from fleet to vent ahood oh yea the truck bed is full of junk that get's me out of a jam at 3.00 am

lou,, this is a little high for this set up david

well i have a 5355j 20 hp honda ts 2021 and it has work great for me the fuel pump on the burner went out today think i have 1100 hrs on it and it's 1.5 old david

what part of okla. i'm based out of east tx .and this would give a chance to go back home some ,,,, david or call me at 903-312-0791

did you change your tips to match new pump ? if that does not work change unloader or check it and mke sure there is no trash in it

psi need's to be match ed or close if one is doing 4,000 and the other 3,000 psi the,3,000 will not open.as for one hose i have seen a 3/8 hose do close to 8.gpm at 3000 ........ david clean strk if you would like you can call me 903-312-0791

so you don't push water back ,cause if one mach goes down to will not damage the other one ..i know this sound werid but i have seen this happen before .

yes need to match psi on both mach.and have a high psi check valveon both

cool paul you have all the hookup on stuff that's a lot cheap then one's i have seen out here david

need so more info on what you trying to do or call me 903-312-0791 david

okay it's my turn. i have had 5 ps all crew cab's and have loved them all and i have had great luck out of them .....i had a work truck flat bed style it had over 250,ooo on it and was put to the test ......and come out smelling like a rose at the end . just did the nrom. maint. on them and ran like new ........just me thinking out loud .....david

hey thank's for the help ... i didn't mean to start a debate ..i think you should always have all the info. on the chem's that you use and tell the folk's around about it the danger of it as i worked the oilfield for 18 yr's and was around some bad stuff from acid to hand soap .....david

i have seen this type in action in austin tx and it need's a min a 6.5 gpm to work well , like jon said it's heavy......david

i would use gz or 6136 but shipping will kill me on cost .or is the a dealer in the dallas tx area that has it ??