Tmrrptr 164 Report post Posted September 26, 2007 I put pump saver in one of my airless pumps the other day, that had not been run in a week, and a bit of rusty water came out as the pumpsaver went in... not great. So I figured it would be a good idea to run some through my PW pumps, also. While at HD on another project I found PVC fittings that would do the trick. The 3/4 male <<hosebib>> thread to slip fitting was just the ticket, and threaded into the filter inlet. HD also carries the street 90, which fits right into the other. No glue, I just turned it up, and the volume was enough to get some coming out the pressure side of the pump when I pulled the motor over a couple times. Ingredients in pump saver probably same as antifreeze. For the 2 bucks spent, I feel better! r Share this post Link to post Share on other sites
