Celeste 341 Report post Posted November 18, 2005 This is an ipe floor on a screened in porch. The wood is approximately 2-3 years old with no sealer. Share this post Link to post Share on other sites
0 Celeste 341 Report post Posted November 18, 2005 Roger cleaned it with EFC-38 at a mix ratio of about 6:1. Share this post Link to post Share on other sites
0 Celeste 341 Report post Posted November 18, 2005 After application of Citralic and thorough rinsing. Share this post Link to post Share on other sites
0 steve r 14 Report post Posted November 18, 2005 Roger cleaned it with EFC-38 at a mix ratio of about 6:1.the floor looks good wet .shoot some after pics ltr Share this post Link to post Share on other sites
0 Celeste 341 Report post Posted November 18, 2005 Dry & ready to stain. Share this post Link to post Share on other sites
0 Celeste 341 Report post Posted November 18, 2005 Hand rubbed with Wood Tux Wet, 2:1 with water - no tint added. (and now it's time to get a new camera!) Share this post Link to post Share on other sites
0 Neil_Asheville 114 Report post Posted November 18, 2005 :lgbow: What did you use to mask the brick and rail while cutting in the edge? Share this post Link to post Share on other sites
0 Celeste 341 Report post Posted November 18, 2005 I used a piece of cardboard next to the brick and simply ran a tape barrier on the white boards. Since it was entirely hand done (and I have the black & blue knees to show for it) it was more because I get wiggly-handed. Had we sprayed it may have been a bit differently covered. Celeste Share this post Link to post Share on other sites
This is an ipe floor on a screened in porch. The wood is approximately 2-3 years old with no sealer.
Share this post
Link to post
Share on other sites