harrellsm

Sorry I've been gone for a while. I just am getting caught up enough to try this again. Knock on wood.

OK guys, When I get home from work this afternoon I will try using the bolts in the larger holes. Also, one of my friends at work has loaned me a gear/wheel puller, in case that doesn't work. Thanks! Sean

Hi Chris, There isn't any set screw that I can see. Let me try to attach a picture of it. There is a keyway with a groove on the other side but thats all I can see. Thanks, Sean

Hi All, I just bought my first belt drive cold water gas washer. I bought it used and it has plenty of miles on it but the Honda GX390 motor started right up and the price was right so I took a chance. My question is this, the pump, AR XRCA 4G40H, needs to be serviced and I want to do it off the machine. The unit has 3 belts and I have removed those but I have to get the pulley off the shaft and I am not sure what puller to use. There isn't a center bolt, it has a keyway in the center. The pulley has 3 small bolts in a triangle around the center so I am thinking those are for the puller. So, do I attach the puller and start turning the bolt? Or do I have to figure out what to do about the keyway? Many thanks, Sean PS. The washer doesn't have any manufacturers markings that I can see. It's got a lot of concrete splatter on it. A lot!:))