Chappy 138 Report post Posted February 7, 2012 How hard would it be to make my own dual turbo nozzle? would a wand and a t work? The ones Ive seen are welded with more of u than a T. But with few exceptions, no distributer carries them, good distributers anyway. I dont trust northern tools stuff. what would be the problems you would foresee? If you ran 8gpm at 4000 psi, two 4s rated at 3000 would suffice, right? Share this post Link to post Share on other sites
mick m 19 Report post Posted February 8, 2012 Hi Chappy. The reason there made with a bend as opposed to 90* corners is that water flows faster round a bend than a corner. I had a try of one a couple of years ago. After about 3 minutes my fingers were tingling like hell. They vibrate something shocking. Share this post Link to post Share on other sites
Chappy 138 Report post Posted February 8, 2012 well, used to the vibration of one, how much more could a double be? qeustion is do they last? or is the vibration going to cause it to fail quickly? Share this post Link to post Share on other sites
mick m 19 Report post Posted February 9, 2012 well, used to the vibration of one, how much more could a double be? qeustion is do they last? or is the vibration going to cause it to fail quickly? I think if anything is going to fail, it will be the welds. And as for how much worse the vibration could be, it's more of a shake. your hands will feel like you got a severe case of pins & needles. If you tap your finger tips together, they will sting! Share this post Link to post Share on other sites
