XJET Problems ?

[Guest rfitz]

I have taken apart my xjet, and there is no blockage, but

it only seems to be drawing at about a 1 to 10 maybe 20 ratio,

and if I point my wand straight up in the air, like to do gutters

it wont draw at all, it makes it up about 2/3 the length of the hose

and then stops, it is only a few months old, and I ve only used it a

few dozen times.. Anyone else seem to have problems with this

thing ?

THX

[One Tough Pressure 580]

I do not own an X Jet, but would start looking over the inlet hose very well.

Make sure there are no blockages, and no air leaks. Depending on how you store it, or chemicals that you use, it may have a crack in it somewhere.

Good luck

[ParadiseProWash 14]

Hold your wand straight and squeeze the trigger and let it start drawing chemical then raise your wand it should continue to draw I have to do it this way when using it on an extension wand it must start drawing all the way up the hose before you raise your wand I hope this helps you out.:D