Jimmy M 14 Report post Posted March 8, 2006 I use a homemade set up for spraying stain. 1.8 gpm-60 psi shurflo with the deckster wand. I know backbrushing is a must but I wonder how wtw will spray using this setup. I saw a previous thread about this but have not been able to find. Share this post Link to post Share on other sites
0 Jimmy M 14 Report post Posted March 9, 2006 Can't believe nobody is using this setup to spray this stuff. Share this post Link to post Share on other sites
0 Russell Cissell 65 Report post Posted March 9, 2006 If you are planning to back brush anyway, you might consider switching to a flood jet tip to increase your overall application speed. Share this post Link to post Share on other sites
0 Beth n Rod 1,279 Report post Posted March 9, 2006 We use the decker spray system and keep the PSI between 100-150. Works like a charm. Beth Share this post Link to post Share on other sites
0 Beth n Rod 1,279 Report post Posted March 10, 2006 Jimmy, You will need around 150psi to spray WTW and a larger spray tip (orifice size) Your current set up spec's will do fine for chem applications though... Rod!~ Share this post Link to post Share on other sites
I use a homemade set up for spraying stain. 1.8 gpm-60 psi shurflo with the deckster wand. I know backbrushing is a must but I wonder how wtw will spray using this setup. I saw a previous thread about this but have not been able to find.
Share this post
Link to post
Share on other sites