Doing a two tone on a deck that I was unable to remove all the behr solid off of. Rails will be white and WHG WTW on the surface
Im wondering what part do I paint white though? The fascia board still has a bit of behr on it so I was hopeing to do that that white, but will it look better stained? I can sand it off if necessary. And the supports? Should they be white or warm honey gold? Same with the stringers for the stairs?
Basically I was just planning on staining the part you actually walk on (ie the step treads and the decking boards) and everything else (verticals) in white, but Im worried it might be too much white.
The picture shows the parts im not sure about. The white circle is stuff that is getting done in white. The spindles, rails, rail cap and rail posts. The yellow is what im not sure about.
Doing a two tone on a deck that I was unable to remove all the behr solid off of. Rails will be white and WHG WTW on the surface
Im wondering what part do I paint white though? The fascia board still has a bit of behr on it so I was hopeing to do that that white, but will it look better stained? I can sand it off if necessary. And the supports? Should they be white or warm honey gold? Same with the stringers for the stairs?
Basically I was just planning on staining the part you actually walk on (ie the step treads and the decking boards) and everything else (verticals) in white, but Im worried it might be too much white.
The picture shows the parts im not sure about. The white circle is stuff that is getting done in white. The spindles, rails, rail cap and rail posts. The yellow is what im not sure about.
Share this post
Link to post
Share on other sites