Chemical injector for downstreaming?

[rj242 16]

I have been using an xjet for washing houses, but have become curious about downstreaming after reading all the post on the subject. I have a 3500psi/5.6gpm washer and it came with what looks like an Adams chemical injector. My question is will this type of injector work? or do I need one of the higher draw injectors? I believe the Adams is suppose to go up to 20%, but they recommend a hose length of 100ft or less. I usually need 150-200ft of hose.

If my Adams injector is enough, then what would be a good Simple Cherry/12.5%SH mixture for downstreaming with this rig. Also how long does it take for the chemical to go through the lines (150-200ft)?

[PressurePros 249]

Any injector works fine with up to 200 ft of hose. Get yourself a gun made for use with high volume machines (12gpm+). I've used Simple Cherry at 2 scoops in a gallon of warm water plus 3.5 gallons of 12.5% plus to remove nasty buildup on vinyl with no problems.

Polish up your X-Jet.. it makes a pretty paperweight. I'm teasing, the X-Jet is still important in a professional arsenal for stucco or laying down chems on concrete. For vinyl though.. waste of time and chemicals.

[douseahouse 21]

hey ken,

i'm assuming that you are talking about a 5 gallon mix. just wanted to clarify in case someone got confused (like me).

rando

[PressurePros 249]

Little under five gallons Randy. You wouldn't have any problem topping off with more water to fill a pail to the top.

[rj242 16]

yes i was talking about a 5 gal bucket