big mike 14 Report post Posted May 19, 2005 I want to make separate lines for stripper / brightener / stain on my shurflo setup. Question 1. who carries these at a reasonable price? Question 2. What type is everyone using? i.e. flow thru, double stop, etc. Question 3. Do I need stainless for the chemicals or is brass OK? The idea is to save time and material by not having to purge the line after each process. I can just disconnect one line, and clikck on the next. Share this post Link to post Share on other sites
tropical wave 22 Report post Posted May 20, 2005 our setup is shown in a new thread called shurflo setup .....we have brass QC's on ours with little brass ball valves on both ends of our hoses, when were done with the stripper, turn off the pump, close the ball valves, QC the hose and swap out to the second hose, load the cart with a bucket of ox and away we go.........when we're done for the day I run a bunch of water thru all the hose, the pump and guns.......everything is brass (even the cone tip, the adapter hardware etc) except the plugs of course and theres been no probs yet....a little discoloration here and there, but I run a lot of water thru when were done for the day Share this post Link to post Share on other sites
CCPC 26 Report post Posted May 20, 2005 I use all nylon fittings and a pvc wand for delivery. The only metal in my shurflo setup is a few stainless couplers and plugs. Share this post Link to post Share on other sites
