Aplus 525 Report post Posted July 3, 2005 I need a set screw for my AR pump that holds in the keyway. I've went to HD, Lowes and a couple local hardwares, but they did not have the right thread size. A standard 1/4" almost fits but is a different thread pattern. Does anyone have an old dead pump lying around that may have such a set screw, or does anyone have a source for a new one? Thanks! Share this post Link to post Share on other sites
Scott Stone 604 Report post Posted July 3, 2005 Sounds metric. Go to a bolt store. they would probably have it. Scott Stone Share this post Link to post Share on other sites
Russ Johnson 141 Report post Posted July 3, 2005 I'll check a little later today and see if I have one...just threw out a bunch of old pumps. Share this post Link to post Share on other sites
signal444 14 Report post Posted July 3, 2005 http://pressure-washer-parts.com/pump_ar.asp Share this post Link to post Share on other sites
Russ Johnson 141 Report post Posted July 5, 2005 Tony, you still looking for a setscrew? I just got a junk pump in today and it has one on it. PM me your address, and I' ll drop it in the mail. Share this post Link to post Share on other sites
Aplus 525 Report post Posted July 6, 2005 Yes....just pm'd you. Share this post Link to post Share on other sites
Aplus 525 Report post Posted July 12, 2005 Hey Russ.....thanks for sending the set screw....the problem is, it caused a little rip in the envelope and the set screw apparently squirted out. I can't believe that happened. Needless to say, I'm still in need of a set screw. Share this post Link to post Share on other sites
Russ Johnson 141 Report post Posted July 12, 2005 I was just "screwin'" with you and sent you an empty envelope. Let me see if I can dig up another one. Share this post Link to post Share on other sites
Russ Johnson 141 Report post Posted July 12, 2005 Tony, I don't have any more, but I need to place an AR order tomorrow. I'll get you one if you'd like. Share this post Link to post Share on other sites
Aplus 525 Report post Posted July 13, 2005 Russ, Yes, I would appreciate that very much. If you can readily order them, then I'd like two so I can have a spare and never have to bug you again for a dumb metric set screw.....:) Share this post Link to post Share on other sites
Russ Johnson 141 Report post Posted July 13, 2005 Consider it done. I'll send them to you when they come in. Share this post Link to post Share on other sites
Russ Johnson 141 Report post Posted July 20, 2005 Tony, I deleted the pm with your address. Pease do it again and I'll have the screws on the way. Share this post Link to post Share on other sites
Aplus 525 Report post Posted July 22, 2005 Done....THANKS!! Share this post Link to post Share on other sites
