jbruno 14 Report post Posted July 5, 2006 I have a 6 g/min. machine and was thinking of teeing it off for truck washing and some big deck jobs. this way my helper could help (lol). Is it a simple fitting, or is there more to it?? Share this post Link to post Share on other sites
Jarrod 22 Report post Posted July 5, 2006 Don't waste your time. 3 gpm on each gun is useless. Share this post Link to post Share on other sites
Ron Musgraves 240 Report post Posted July 5, 2006 you need a different unloader, you can get more gpm if you can work with lower pressure. Share this post Link to post Share on other sites
Paul Kassander 26 Report post Posted July 5, 2006 Jarrod is right, 3 gpm on trucks will take more time with 2 than just 1 at 6gpm. You will need the flow to do anything with the bugs and other dirt. Share this post Link to post Share on other sites
jbruno 14 Report post Posted July 6, 2006 Jarrod is right, 3 gpm on trucks will take more time with 2 than just 1 at 6gpm. You will need the flow to do anything with the bugs and other dirt. How about Decks?? I was just wondering if it was a simple t valve, or as Ron says an entire new unloader. I would still like to run at 6gpm on most projects, but if I could split off for a deck (without a new unloader) it may be worth the part... Share this post Link to post Share on other sites
Paul Kassander 26 Report post Posted July 15, 2006 It can be done if you are running a trap unloader, the excess water will be sent ino bypass when you install the smaller tip. Take your tip size and cut it in half, one for each gun. When you are running both machines you will get your full 6gpm( 3gpm per machine), when you are running 1 you will still only have 3gpm and the other 3 will be in bypass. to get the full flow you will need to change the tip back to the rated size. You will not be able to run a duall gun with a flow unloader such as a K7 though. If you want to see how one is set up look at the dual man pressure washer on my website, www.mobicleaninc.com or give me a call and I can help you with the setup. Share this post Link to post Share on other sites
