zhamilton89 14 Report post Posted August 16, 2009 Just looking to see what you guys are using to route your exhaust from your engines that are inside of an enclosed trailer, the burner I've got figured out but I just cant seem to find anything to use for my pressure washer motor and two generators. The sizes are 1 1/4 and 3/4, any ideas? Thanks, Share this post Link to post Share on other sites
Scott Stone 604 Report post Posted August 16, 2009 Napa, Flexible exhaust tubing. They have it, or should. Share this post Link to post Share on other sites
Pat Norman 18 Report post Posted August 16, 2009 I need to get about two feet myself. I need to divert my exhaust. Right now it is less than two feet from my pressure hose reel and gets my hose quite toasty! 'Fraid it may burn or mess up my hose. Share this post Link to post Share on other sites
Alexy 85 Report post Posted August 16, 2009 Extend your exhaust up and plumb the engine exhuast up and out thru the burner duct as well. Share this post Link to post Share on other sites
zhamilton89 14 Report post Posted August 16, 2009 The pressure washer exhaust will be going out the same way as the burner but the generator's will have to go out some manifolds on the side Share this post Link to post Share on other sites
acegot 14 Report post Posted August 17, 2009 The pressure washer exhaust will be going out the same way as the burner but the generator's will have to go out some manifolds on the side Your generators are stationary? On my old setup I tack welded a pipe nipple to the muffler & then the the flex tube to nipple then cut a hole in the floor with a hole saw & ran it out the bottom with an insulator around it. Share this post Link to post Share on other sites
zhamilton89 14 Report post Posted August 17, 2009 They are mounted, but I will be doing the same thing as you did acegot, by manifold I mean a metal ring in the floor with sch. 40 black pipe through it so no air/water gets in. The flexpipe will be between the muffler and the floor pipe Share this post Link to post Share on other sites
acegot 14 Report post Posted August 17, 2009 You got it! Share this post Link to post Share on other sites
