Camelot 68 Report post Posted October 31, 2006 Does anyone know what the water to NMD80 ratio is for a 5 gallon bucket if I am Xjetting it with a 4 gpm 4000psi machine? I need to know what the ratio is for both S and N type mortars. Thanks in advance for any help you can offer. - John Share this post Link to post Share on other sites
0 Craig 111 Report post Posted October 31, 2006 1:4 is standard cutting. More or less depending on your situation. If you are X-Jetting full strength then I'd cut it 1:2 in your bucket so you end up with a 1:4. Share this post Link to post Share on other sites
0 Camelot 68 Report post Posted October 31, 2006 Thanks Craig! I appreciate the help. - John Share this post Link to post Share on other sites
0 copgib 15 Report post Posted March 5, 2008 Craig, I just ordered some NMD80 to clear up some white stain on bricks. Will it normally work? Or am I wasting my money. Hugh Share this post Link to post Share on other sites
0 Beth n Rod 1,279 Report post Posted March 5, 2008 Hugh, I think Celeste and Roger have used a good bit of NMD80. I'll shoot her a message to check this thread. Beth Share this post Link to post Share on other sites
0 Doug Dahlke 114 Report post Posted March 5, 2008 You can also call the manufaturer. I use some of thier products and they have always been very helpful with questions. Share this post Link to post Share on other sites
0 Celeste 341 Report post Posted March 5, 2008 Hugh, NMD80 will take care of some "white stains" on bricks. If you call EaCoChem and explain the discoloration in detail, including if it is powdery versus crusty or even hardened, they will tell you exactly which product to use and explicit instructions of how to do it. Roger will be home tonight if you want to call him directly. 336-516-6139 Share this post Link to post Share on other sites
Does anyone know what the water to NMD80 ratio is for a 5 gallon bucket if I am Xjetting it with a 4 gpm 4000psi machine? I need to know what the ratio is for both S and N type mortars. Thanks in advance for any help you can offer.
- John
Share this post
Link to post
Share on other sites