An idea for removing latex paint from decks

[plainpainter 217]

I was experimenting with cleaning some of paint brushes loaded with dried

latext paint. One of my experiments consisted of a capful of downy fabric softener and 1/8 cup of tsp mixed into a paint bucket (approx 1 gallon) of scalding hot water. Within 30 seconds - the dried latex paint on the wood handles emulsified and came off in the same consistency that sealers come off my decks when I strip them with caustic strippers. But this was old dried out cured latex house paint! So I thought maybe some of you guys with hot pressure washers could experiment with using really hot water and downstreaming a strong solution of tsp and a surfactant - and then rinsing with really hot water - to see if there is a cheap way of removing latex paint. Now you'll probably raise the grain of the wood - but in this kind of situation, doing a little sanding after probably would beat really expensive causting paint strippers. Just a thought

[danster 15]

Thanks Daniel,

I'll give it a shot and let you know. I have a little project right now that I'm doing and will try it tommorrow.

Dan

[Beth n Rod 1,279]

Sounds like the same results as if using a heat gun to strip paint with. Get it hot enough and it will come off.

Downey fabric softener eh?....no wonder I itch after my clothes have had that stuff on it. lol

Rod!~

[plainpainter 217]

yeah - but a heatgun is localized and time consuming - and it doesn't emulsify the paint like my little experiment did. And it did this in like 30 seconds.

[Roger Oakley 14]

I thought Hot water for wood was a no no?

Scalding hot water even more so?

If I'm wrong then I stand corrected.

[James 625]

Just use a Turbo Nozzel and buff later!! I love the Turbo on wood!!!

[plainpainter 217]

Hot water is a no-no for wood - but so is latex paint. There will have to be sanding done with this technique. Just thought it might alot quicker and cheaper than paint strippers. And most times I have seen decks where lots of paint stripper was applied - lots of sanding was still involved.

[John.Harper 14]

i've done a deck with a floor sander used to finish hardwood floors just have to be really careful about the wood dust that comes up there will be nasty stuff in there if its pressure treated